Plastering is applying a smooth finishing coat of plaster to walls and ceilings, either as a thin skim over sound surfaces or as a full re-plaster after removing failed plaster, creating a flat surface ready for decoration.
Getting plastering and skimming right in Wellington starts with understanding the house you already have: its age, how it was built and what has been altered over the years. We survey first, then commit on paper to a price that holds as long as the scope stays the same. Across the West Midlands, guide prices run at £550–£1,550 including VAT, and homes in Telford, Shrewsbury and Stafford are covered too.
- Guide price
- £550–£1,550 inc VAT
- Time on site
- 1–3 days per room, plus drying time
- Postcodes
- TF1 and TF5
- Planning rules
- England
- Local area
- Telford and Wrekin
- Survey
- Free, with a written quote
How much does plastering and skimming cost in Wellington?
Use the table to gauge the cost of plastering and skimming in Wellington before we visit. Figures include VAT and are scaled for the West Midlands, coming out about 2% below the national guide, which gives £550–£1,550 overall. After a free survey, you receive a fixed written price.
| Type of job | What it usually involves | Guide in Wellington |
|---|---|---|
| Patch repairs or one wall | Repairing cracks, filling cable channels after a rewire or skimming a single wall. | £150–£500 |
| One room, walls and ceiling | Skimming or boarding and skimming the walls and ceiling of a typical room. | £550–£1,550 |
| Whole house | Skimming or re-plastering most rooms in a typical 3-bed house during a renovation. | £4,900–£12,000 |
The main things that change the figure:
- Total wall and ceiling area to be plastered
- Skim over sound plaster or full re-plaster back to brick
- Ceiling height, stairwells and access
- Removing artex, wallpaper or failed plaster first
Scope of the work
- Survey of walls and ceilings, including tap-testing for hollow plaster
- Removal of loose or failed plaster and old wallpaper
- Plasterboard fixed to ceilings or walls where needed
- Angle beads and stop beads for straight corners and edges
- Skim coat or full two-coat plaster to agreed areas
- Waste removal and a tidy finish ready for decorating
Homes in Shropshire
Shrewsbury and Ludlow are known for black-and-white timber-framed buildings alongside Georgian brick, and red sandstone is common in the north of the county. Telford was built as a new town from the late 1960s with large planned estates, and market towns such as Oswestry, Bridgnorth and Whitchurch mix historic centres with interwar and newer housing.
Timber-framed and stone buildings often need lime plaster, breathable finishes and roof repairs. Telford homes commonly suit extensions, window replacement and roofline or cladding renewal.
So when we survey a Wellington property for plastering and skimming, the first step is working out how it was built and what has been changed since.
Permissions for plastering and skimming in Wellington
England, Wales, Scotland and Northern Ireland each handle planning a little differently. Wellington comes under England, covered below, and we raise any questions with the council before your quote is finalised.
Internal work such as a new kitchen, bathroom, flooring, plastering or decorating does not need planning permission in England, unless the house is listed, when listed building consent may be needed even for internal changes.
Some internal work is covered by Building Regulations: new electrical circuits and work in bathrooms (Part P), new drainage, structural changes, extractor ventilation and any new window. Notifiable work is certified by a registered installer or by building control.
Rules change and every property is different, so we check the planning history and constraints for your address before we quote.
The four stages
A visit to your home
First, someone visits your home in Wellington to see the space, take measurements and note anything that could affect the work, such as access or the condition of what is there. There is no charge for this visit.
Written quote
You get the price in writing, itemised so you can see where the money goes. As long as the specification stays the same, that is the price you pay for plastering and skimming.
Dates and permissions
Preparation matters as much as the build. We agree access, parking and working hours with you, order materials in good time, and confirm any permissions so the job isn't held up once it starts.
The work itself
Work goes ahead as scheduled and you deal with one contact throughout. When the last trade leaves, we clear and clean the site, talk you through what has been done and pass on any certificates and care instructions.
Working with SK Home Improvements
Common questions
How long does new plaster take to dry?
A skim coat usually dries in a few days in a warm, well-ventilated room, while a full re-plaster can take one to four weeks depending on its thickness and the weather. Plaster turns from dark brown to an even light pink when dry. Keep windows open where possible, but avoid blasting heaters, which can cause cracking. We advise on drying before you decorate.
What happens at the survey?
We visit your home at a time that suits you, look at the area involved, take measurements and check access, condition and any services that might be affected. We talk through what you want from plastering and skimming, explain the options and answer questions. There is no charge and no obligation; afterwards we send a written quote.
Should older houses be plastered with lime?
Older homes with solid walls and no damp-proof course are often better with lime plaster, because it lets moisture move through the wall and evaporate. Modern gypsum plaster can trap moisture in these walls, which can cause damp patches and blown plaster. Lime takes longer to apply and dry, so it costs more. We check your wall construction before recommending a material.
Which postcodes in Wellington do you cover?
We cover TF1 and TF5, along with the rest of Shropshire. If your postcode is not listed, get in touch anyway: our coverage is UK-wide, and we can usually arrange a survey wherever you live. Enter your postcode in the guide-price tool or contact form and we will confirm.
Why is my plaster cracking?
Fine cracks in new plaster are usually shrinkage cracks from drying too fast and are easily filled before decorating. Cracks along plasterboard joints often mean missing tape or movement in the boards. Larger or diagonal cracks over doors and windows can point to structural movement and should be looked at before re-plastering. We assess cracks during the survey and explain the likely cause.
Near Wellington
From TF1 and TF5 to the edges of Wellington and on into Telford, Shrewsbury and Stafford, we can arrange a site visit and a written quote for your project, planned around dates that work for you.