Wall removal is taking out an internal wall to open up rooms; where the wall is load-bearing, a steel beam sized by a structural engineer is installed on padstones to carry the weight above, with the work approved by building control.
We offer removing a wall throughout Cambridgeshire, from Peterborough, Cambridge, Wisbech and St Neots to the smaller places in between. Each project starts with a free survey at your home and ends with a written figure, fixed for the work you choose. Because Cambridgeshire is in England, we work to the planning system and building standards used there, and guide prices for the East of England run at £3,200–£8,400 including VAT.
- Guide price
- £3,200–£8,400 inc VAT
- Time on site
- 1–3 weeks including making good
- Planning rules
- England
- Price level
- About 5% above the national guide
- Towns listed
- 8
- Survey
- Free, with a written quote
Wall removal and steel beams prices in Cambridgeshire
What will removing a wall cost in Cambridgeshire? Our guide range is £3,200–£8,400 including VAT. That figure is adjusted for the East of England, about 5% above the national guide, and is intended for planning a budget. A firm written price for your chosen specification follows a free survey at your home.
| Type of job | What it usually involves | Guide in Cambridgeshire |
|---|---|---|
| Non-load-bearing wall | Removing a stud or block partition and making good walls, ceiling and floor. | £850–£2,100 |
| Load-bearing wall up to 4m | A typical kitchen-diner knock-through with one steel beam, calculations and building control. | £3,200–£8,400 |
| Wide or complex opening | Openings over 4m, posts, flush beams or chimney breast removal. | £8,400–£17,000 |
What moves the price up or down:
- Opening width and the load the wall carries
- Beam size, posts, flush fixing and padstone details
- Services in the wall that need rerouting
- Floor and ceiling repairs where the wall stood
What do you get?
- Survey to establish what the wall supports and where loads go
- Structural engineer's calculations and beam specification
- Building control application and inspections
- Temporary propping and dust protection during the work
- Steel beam installed on padstones and packed tight
- Beam boarded or treated for fire protection
Housing across Cambridgeshire
Cambridge has many Victorian terraces in pale gault brick, with Edwardian villas and modern estates around the city. Peterborough expanded as a new town from the 1970s, adding large planned estates, while Ely, Huntingdon, St Neots and the Fenland market towns keep Georgian and Victorian centres. Limestone appears in villages near the Northamptonshire border.
Narrow terraces commonly suit loft conversions and kitchen extensions. Newer estate homes often need garage conversions, porches and landscaping, and older brick and stone buildings may call for lime-based repointing and carefully specified windows.
This is one of the driest parts of the UK, but open fenland is windy and peat or clay ground can shrink, affecting foundations.
Do you need permission in Cambridgeshire?
For anyone in Cambridgeshire, the relevant framework is England's. The summary below is general, so we always contact the council about your address before putting a price in writing.
Removing an internal wall does not need planning permission in England unless the house is listed.
If the wall is load-bearing, Building Regulations approval is needed, with a structural engineer’s calculations for the steel beam and padstones. Where the beam bears on a shared wall, the Party Wall etc. Act 1996 applies.
Rules change and every property is different, so we check the planning history and constraints for your address before we quote.
From survey to handover
A visit to your home
Book a visit and we'll come to you. The survey covers measurements, the state of what's there now and any obvious constraints, so the price that follows is based on your actual home, not an average.
Written quote
We turn the survey notes into a written quote. The price is fixed for the specification we agree, and the document sets out materials, scope and payment stages in plain language.
Getting ready
With the quote agreed, we book the work in and handle preparation: permissions where needed, building control notifications, material orders and access arrangements for your Cambridgeshire property.
Finish and handover
Work goes ahead as scheduled and you deal with one contact throughout. When the last trade leaves, we clear and clean the site, talk you through what has been done and pass on any certificates and care instructions.
What you can expect from us
Questions about removing a wall in Cambridgeshire
Do I need building regulations approval to remove a wall?
Removing a load-bearing wall needs building regulations approval anywhere in the UK, and in Scotland a building warrant. A structural engineer calculates the beam and supports, and building control inspects the work. Removing a non-structural wall may still need approval if it affects fire escape routes, such as opening a hallway into a living room. We handle the applications and inspections.
Does the Party Wall Act apply to wall removal?
The Party Wall etc. Act 1996 applies in England and Wales only. Removing an internal wall usually does not involve it, but if the beam bears into a wall shared with a neighbour, as is common in terraced and semi-detached houses, you must serve notice first. Scotland and Northern Ireland have no equivalent Act. We tell you during the survey whether notices are needed.
Which postcodes in Cambridgeshire do you cover?
We cover PE1, CB2, PE13 and PE19, along with the rest of Cambridgeshire. If your postcode is not listed, get in touch anyway: our coverage is UK-wide, and we can usually arrange a survey wherever you live. Enter your postcode in the guide-price tool or contact form and we will confirm.
Can I have a beam that does not show?
A flush or hidden beam sits within the depth of the ceiling so there is no visible downstand, giving a clean, open look. It is possible where the floor joists can be connected into the side of the beam, which takes more steel and labour. It costs more than a standard beam below the ceiling. The engineer confirms whether it suits your house.
How long will removing a wall take?
On a typical home, allow 1–3 weeks including making good. Larger projects, older buildings and extra work found once things are opened up can extend that, while simpler jobs may be shorter. Your quote includes an estimate of time on site, and your point of contact keeps you updated on the programme as the work progresses.
Towns in Cambridgeshire
We offer removing a wall in each of the towns below, all within Cambridgeshire. Select yours for guide prices, postcodes covered and nearby places.