Wall removal is taking out an internal wall to open up rooms; where the wall is load-bearing, a steel beam sized by a structural engineer is installed on padstones to carry the weight above, with the work approved by building control.
Across Tyne and Wear, people look into removing a wall to replace something worn out, to make the house work better for them, or to get it ready for a sale. We cover Newcastle upon Tyne, Sunderland, South Shields and Gateshead and the smaller towns around them, working to the rules that apply in England. Expect a guide of £2,700–£7,200, VAT included, in the North East, and every quote follows a free visit.
- Guide price
- £2,700–£7,200 inc VAT
- Time on site
- 1–3 weeks including making good
- Planning rules
- England
- Price level
- About 10% below the national guide
- Towns listed
- 15
- Survey
- Free, with a written quote
Wall removal and steel beams prices in Tyne and Wear
Here is how the guide price for removing a wall breaks down in Tyne and Wear. We start from national figures and adjust for the North East, which comes out about 10% below the national guide. The resulting range, VAT included, is £2,700–£7,200, and a survey, at no cost to you, firms it up.
| Type of job | What it usually involves | Guide in Tyne and Wear |
|---|---|---|
| Non-load-bearing wall | Removing a stud or block partition and making good walls, ceiling and floor. | £700–£1,800 |
| Load-bearing wall up to 4m | A typical kitchen-diner knock-through with one steel beam, calculations and building control. | £2,700–£7,200 |
| Wide or complex opening | Openings over 4m, posts, flush beams or chimney breast removal. | £7,200–£14,500 |
Your price depends mostly on:
- Opening width and the load the wall carries
- Beam size, posts, flush fixing and padstone details
- Floor and ceiling repairs where the wall stood
- Engineer, building control and any party wall costs
Scope of the work
- Survey to establish what the wall supports and where loads go
- Structural engineer's calculations and beam specification
- Building control application and inspections
- Wall taken down and waste removed from site
- Steel beam installed on padstones and packed tight
- Beam boarded or treated for fire protection
Homes in Tyne and Wear
Tyneside flats, pairs of upper and lower flats behind a terraced front, are a distinctive feature of Newcastle and Gateshead. Sunderland is known for its single-storey terraced 'Sunderland cottages', and both cities have Victorian brick and stone terraces, interwar estates and post-war housing. Washington was built as a new town from the 1960s.
Terraces and Tyneside flats commonly need repointing, roof work and window replacement. Houses suit loft rooms and rear extensions, and new-town homes often take garage conversions and cladding upgrades.
Cold North Sea winds and sea frets affect the coast at Tynemouth and South Shields, and former coal workings underlie parts of the area.
Do you need permission in Tyne and Wear?
Tyne and Wear is in England, so the planning and building rules set out below are the ones that apply. We confirm the details with the council before we quote.
Removing an internal wall does not need planning permission in England unless the house is listed.
If the wall is load-bearing, Building Regulations approval is needed, with a structural engineer’s calculations for the steel beam and padstones. Where the beam bears on a shared wall, the Party Wall etc. Act 1996 applies.
Rules change and every property is different, so we check the planning history and constraints for your address before we quote.
From survey to handover
Survey and measure
We arrange a free site survey on a date convenient to you. We measure up, look at the existing structure and access, and discuss your plans for removing a wall so the price reflects your home.
Quote in writing
We turn the survey notes into a written quote. The price is fixed for the specification we agree, and the document sets out materials, scope and payment stages in plain language.
Dates and permissions
Once you accept, we agree start dates, order materials and deal with any planning, building control or neighbour notices the job needs. You'll know who is coming and when before work begins.
On site to finish
Work goes ahead as scheduled and you deal with one contact throughout. When the last trade leaves, we clear and clean the site, talk you through what has been done and pass on any certificates and care instructions.
What you can expect from us
Questions about removing a wall in Tyne and Wear
How long will removing a wall take?
On a typical home, allow 1–3 weeks including making good. Larger projects, older buildings and extra work found once things are opened up can extend that, while simpler jobs may be shorter. Your quote includes an estimate of time on site, and your point of contact keeps you updated on the programme as the work progresses.
How do I know if a wall is load-bearing?
A wall is load-bearing if it carries weight from above, such as floor joists, another wall, the roof or a chimney. Clues include joists running across the wall rather than alongside it, and walls lined up with walls on the floor above. Brick or block walls are often structural but not always. We check from above and below during the survey, and an engineer confirms the design.
How much does it cost to remove a load-bearing wall?
Removing a load-bearing wall of about 3–4m with a steel beam typically costs £2,700–£7,200, including structural calculations, building control and making good. A non-load-bearing partition costs much less. As a rough guide, allow around £600–£1,600 per metre of opening plus fixed costs for the engineer, approvals and propping. Wider openings, posts and flush beams cost more. We confirm a fixed price after the survey.
What happens to pipes and cables in the wall?
Pipes, cables and radiators in a wall being removed must be rerouted before demolition. Electrical work is done and certified by a qualified electrician, and pipework is diverted by a plumber, usually through the ceiling void or floor. We identify services during the survey and include rerouting in the quote, so there are no surprises once work starts.
Who do I deal with during the job?
One point of contact manages your project from survey to handover. They schedule the trades working under our contract, keep you updated on progress, and are the person to call with any question. You don't need to coordinate builders, electricians or decorators separately, because that is part of what we do.
Towns in Tyne and Wear
Choose your town from the list to see how we price and plan removing a wall in your part of Tyne and Wear, including typical time on site.