Wall removal is taking out an internal wall to open up rooms; where the wall is load-bearing, a steel beam sized by a structural engineer is installed on padstones to carry the weight above, with the work approved by building control.
Homeowners in Perth usually consider removing a wall for one of a few reasons: something has worn out, the house no longer suits the way they live, or they are getting it ready to sell. We visit, agree a specification and put a fixed price in writing. Most jobs like this take 1–3 weeks including making good, and we work across Perth and Kinross, including Auchterarder, Blairgowrie and Crieff.
- Guide price
- £2,900–£7,700 inc VAT
- Time on site
- 1–3 weeks including making good
- Postcodes
- PH1 and PH2
- Planning rules
- Scotland
- Local area
- Perth and Kinross
- Survey
- Free, with a written quote
How much does removing a wall cost in Perth?
Use the table to gauge the cost of removing a wall in Perth before we visit. Figures include VAT and are scaled for Scotland, coming out about 4% below the national guide, which gives £2,900–£7,700 overall. After a free survey, you receive a fixed written price.
| Type of job | What it usually involves | Guide in Perth |
|---|---|---|
| Non-load-bearing wall | Removing a stud or block partition and making good walls, ceiling and floor. | £750–£1,900 |
| Load-bearing wall up to 4m | A typical kitchen-diner knock-through with one steel beam, calculations and building control. | £2,900–£7,700 |
| Wide or complex opening | Openings over 4m, posts, flush beams or chimney breast removal. | £7,700–£15,500 |
What moves the price up or down:
- Opening width and the load the wall carries
- Services in the wall that need rerouting
- Floor and ceiling repairs where the wall stood
- Engineer, building control and any party wall costs
What does the job include in Perth?
- Survey to establish what the wall supports and where loads go
- Structural engineer's calculations and beam specification
- Temporary propping and dust protection during the work
- Wall taken down and waste removed from site
- Beam boarded or treated for fire protection
- Plastering, flooring repairs and making good ready for decorating
Building in Perth
Perth has Georgian terraces and Victorian sandstone villas, Highland Perthshire towns such as Pitlochry and Aberfeldy have stone villas and cottages, and Kinross and Crieff mix older stone housing with post-war and modern estates. Slate roofs and harled finishes are common in rural areas.
Sandstone villas in Perth and Highland Perthshire often need repointing and slate roof repairs, and many sit in conservation areas. Semis and newer homes commonly take extensions, garage conversions and garden landscaping.
With that background in mind, here is how we typically handle removing a wall for homes in Perth, from the first visit to the finished result.
Do you need permission in Perth?
Planning law differs across the UK. For a home in Perth, it is the Scotland rules below that count, and we check them with the council ahead of any quote.
Removing an internal wall does not need planning permission in Scotland unless the building is listed.
Removing a load-bearing wall needs a building warrant and a structural engineer’s design. In tenement flats, the common parts and other owners’ interests also have to be considered.
Rules change and every property is different, so we check the planning history and constraints for your address before we quote.
How does the job run?
A visit to your home
Book a visit and we'll come to you. The survey covers measurements, the state of what's there now and any obvious constraints, so the price that follows is based on your actual home, not an average.
Written quote
We turn the survey notes into a written quote. The price is fixed for the specification we agree, and the document sets out materials, scope and payment stages in plain language.
Dates and permissions
With the quote agreed, we book the work in and handle preparation: permissions where needed, building control notifications, material orders and access arrangements for your Perth property.
Finish and handover
The work is carried out to the agreed specification, with floors and furniture protected and the site kept tidy. At the end we clean up, walk through the finished job with you and hand over any certificates.
What you can expect from us
Common questions
How much does it cost to remove a load-bearing wall?
Removing a load-bearing wall of about 3–4m with a steel beam typically costs £2,900–£7,700, including structural calculations, building control and making good. A non-load-bearing partition costs much less. As a rough guide, allow around £600–£1,600 per metre of opening plus fixed costs for the engineer, approvals and propping. Wider openings, posts and flush beams cost more. We confirm a fixed price after the survey.
How do I know if a wall is load-bearing?
A wall is load-bearing if it carries weight from above, such as floor joists, another wall, the roof or a chimney. Clues include joists running across the wall rather than alongside it, and walls lined up with walls on the floor above. Brick or block walls are often structural but not always. We check from above and below during the survey, and an engineer confirms the design.
What happens to pipes and cables in the wall?
Pipes, cables and radiators in a wall being removed must be rerouted before demolition. Electrical work is done and certified by a qualified electrician, and pipework is diverted by a plumber, usually through the ceiling void or floor. We identify services during the survey and include rerouting in the quote, so there are no surprises once work starts.
Who do I deal with during the job?
One point of contact manages your project from survey to handover. They schedule the trades working under our contract, keep you updated on progress, and are the person to call with any question. You don't need to coordinate builders, electricians or decorators separately, because that is part of what we do.
How much will removing a wall cost in Perth?
As a guide, expect to pay £2,900–£7,700 including VAT for removing a wall in Perth. That range is adjusted for Scotland, which runs about 4% below the national guide. Where your project lands depends on size, materials, access and the condition of what is already there. We confirm a fixed price in writing after a free survey of your home.
Nearby towns
If your address falls within PH1 and PH2, we cover it. The same goes for neighbouring Auchterarder, Blairgowrie and Crieff, which we include alongside Perth when arranging surveys and quotes.